Here it is:

Thanks, I'll try it, downloading openssl now. I noticed right off the bat that http://files.serverscheck.net/conf/ssl.conf doesn't exist anymore, does it have a new link available?

http://wiki.serverscheck.com/index.php/Configuring_Web_Server_in_HTTPS_Mode

I'd like to run the webserver service over SSL to secure the data on my network, is this at all supported in current versions? I found some limited information on google for older versions, which did…

Finally got to the bottom of it..

You are free to use any NMS/EMS you desire since the SensorGateway, which has all the sensors, is SNMP based.

I downloaded the monitoring software from the serverscheck website. That's where i get the graph. where can i get the database logging functionalities and is there any other monitoring software i can…

For historic data you need a monitoring software. Over SNMP historic data is collected. Our monitoring software is free of charge (community based support).

I have the Serverscheck temperature sensor & gateway with me. I have configured it and it works fine. i get the graph of temperature vs time. I want to know if we can see the historical data …

Please also consider testing it to a network without DHCP policies and see if the DHCP functionality would push through.

If it defaults to 2.09 then it must be an early v5 unit.

The hard reset steps for a v5, as stated in the manual, took it back to 2.09, which is what it shipped with, and why I updated originally (our other two have 3.06 out of the box. I then dumped my co…

2.9 is not for v5 devices only v4. v4 does not have oled output so that's why you don't see it.

Yeeeah. It should pull down a ...56.20 IP address based on the config using its MAC address.. I can't even ping it at the IP address its showing on its screen.

Ok. I did just that.

Try reloading the firmware - maybe something wrong happened on the update.

After updating to 3.20 on a new gateway, the sensor status tab in the web interface will not populate anything below its header. Also, the MAC address changed creating issues with the network config.…

Please refer on the following link http://wiki.serverscheck.com/index.php/Monitor_Wizard

I have a 2-sensor gateway with built-in temp, along with a temp/humidity sensor connected. I was able to easily add the gateway as a device during the initial setup, but now am having trouble adding…